Pupils table FrPU1.1.7 single-seat, height

The frame consists of two bent supports made of metal flat-oval tube with cross-section 40x20x1,5 mm and two traverses with cross-section 30x15x1,5 mm.The inner radius of bending of supports is 70 mm.In the inner part of the radius bend there is a "stream" of stiffness.The lower angle of inclination of the workpiece is 80°, the upper one is 100°.On the outer side of the bend of the support is welded support corner made of a metal plate 107h13h1,5mm.On each support is welded two plates from the top and back of the support, the size of 30h35h2mm with a through hole for fixing the lid and the table kingdom.All visible holes in the tube are closed with plastic plugs. To the metal corner, on the outer side of the table leg bend, a plastic corner support 110x95x25mm is attached.On the front edge of the metal supports plastic tips 65x45x25mm are put on.There are 2 hooks. The frame is painted with powder paint.

The table cover is made of LDFP 700x500, thickness 22mm with rounded edges (R-50mm), the table frame is made of LDFP 550x330, thickness 16mm.