Magnetostrictive Level Sensor PMP-201E for Reliable Liquid Level Measurement

The converter is designed to measure parameters of liquid media, including explosive ones, at accounting, calculation and technological operations. The converter provides: <ul> <li>- liquid level measurement;</li> <li>measurement of interface level of two-phase liquid (when equipped with a float of interface); measurement of liquid level.</li> </ul>interface float); <ul> <li>- temperature measurement (multi-point, up to 8 points);</li> <li>liquid density measurement (on the liquid surface, when equipped with a</li> </ul>density measurement (on the liquid surface, when equipped with a density float); <ul> <li>- calculation of liquid density corresponding to the measured temperature,</li> </ul>according to the given initial data of density, temperature and coefficient of volumetric expansion of the liquid; calculation of liquid density corresponding to the measured temperature. liquid expansion coefficient; <ul> <li>- calculation of the density of liquefied hydrocarbon gases (hereinafter referred to as - LHG) corresponding to the measured temperature</li> </ul>LPG) density corresponding to the measured temperature, according to the given component composition composition; <ul> <li>- calculation of liquid volume according to the specified calibration table;</li> <li>calculation of the liquid volume for tanks with simple geometrical shapes</li> </ul>shapes; <ul> <li>- calculation of relative tank filling;</li> <li>calculation of liquid mass;</li> <li>Calculation of the mass of liquid and gas phase of LPG according to the given component composition</li> </ul>composition; <ul> <li>- issuing of control signals when the parameters of liquid media reach the set threshold values and/or in case of malfunction.</li> </ul>specified threshold values and/or in case of malfunction.